CatEye CC-MT [Mity 2] • User guide • Download PDF for free and without registration!. Following pdf manuals are available: cat-eye cc-mt mity 2 User Manual. CatEye product manuals for the entire line of CatEye cycle computers, headlights , safety lights and accessories online support at
|Published (Last):||2 March 2006|
|PDF File Size:||4.5 Mb|
|ePub File Size:||17.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
Keep your eyes on the road and pay attention to traffic conditions.
Cateye mity2 manual
The special rechargeable batteries for this unit are no longer available. F Cordless 7 owner’s manual. With the press of S button, Tm data shifts to the upper display.
Is the wire broken? Periodically check if the screws and secure bands have loosened. If you have mannual on a model not covered here, please send it in.
Incorrect data appears or the screen is frozen. When measuring, the speed scale flashes. Elapsed time is measured from start to current point, in units of hours, minutes and seconds.
To select which weel calibration value to use: If SET button is pressed in stop stateclock time setting dis- play appears. This is only a label, the reading is unaffected.
Operating instructions | CatEye CC-MT [Mity 2] User Manual | Page 2 / 2 | Original mode
C Enduro 2 owner’s manual Mity 3 owner’s manual Battery: DO NOT use abrasives, sandpaper, etc. Using this unit for the first time.
CR lithium If you make a note of the odometer reading before changing batteries, you can re-enter the total distance reading after installing the new battery. Press “SET” msnual advance calibration number. If these buttons are further held down for more than 3 seconds, the wheel circumference moves between A or B. Press the “SET” button again.
Remove and re-install batteries. Current speed does not appear. If SET button is pressed in Odo display stop statewheel circumference setting display appears. Continuously measured until battery wears down. If you hold the “SET” button for 2 seconds or more, you enter the mode to set the alternate “B” calibration number. In Clock Time Setting Display: When current speed does not appear, first short-circuit the contact on the back with metal; if the speed display appears, the main unit is normal and the problem must be in the bracket or the sensor.
The average speed from start to current point is displayed. Press “MODE” right button to enter “odometer setting” mode. Rapidly increases the figure.
Av moves up as Main Display. With Reset operation, it returns to zero.
CatEye CC-MT [Mity 2] manuals
Mity 8 owner’s manual. Maximum speed function is cancelled by use of cadence function. Dst 1, 2 Trip Distance 1, 2 0. Keep your eyes on. Moves between wheel circumference and.
Many bicycle computers are rebranded. Average Pace Arrow D. Enduro 2 owner’s manual. With the press of S button, Mx data shifts to the upper display. The hour display will flash and can be changed using the “MODE” button, more quickly if you hold the button down. For inputting wheel circumference B, hold down SET button. When unit is in “stop” state, neither trip mileage nor total mileage is recorded, but speed and maximum speed functions work. If SET button is pressed in. The clock does not know about daylight savings time: The calibration number will catey.
C Mity 8 owner’s manual Battery: