Embird Digitizing Studio – Tutorial – Tools. Column with Pattern Tool; Create Outline Object Tool; Create Manual Stitches Tool; Create Connection Object Tool . Embird Digitizing Studio – Tutorial – Main Menu – Nodes. Embird Digitizing Studio – Tutorial – Manual Lettering.
|Published (Last):||26 November 2016|
|PDF File Size:||18.14 Mb|
|ePub File Size:||19.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
It allows to create one or two measuring lines. Creation of object symmetrical about both horizontal and vertical axes is explained on the following example: Therefore, stop column at the top ekbird “A”: This tutorial deals with manual digitizing of small satin stitch lettering. The last one is a Measurement Tool.
The next section contains tools for creation of new objects. Digitizing of satin stitch lettering requires use of two ekbird Approach 1 – full control of stitches direction In this case all objects will be drawn manually node-by-node in a specific order.
However, user has less control over the stitches order.
After generation of stitches the column object will look like this: Digitize outer side of letter with a plain fill tool. However, these options serve to snap whole objects not just edited nodes.
To hide connection under cover stitches of the next column, make manula of the “V” shape as illustrated below: Tools Basic tools for creation and editing of vector objects in Studio are located on a left-side panel. If you want to zoom in a specific area, depress the left mouse button and drag mouse to make selection.
Main Menu – Edit
Basic tools for creation and editing of vector objects in Studio are located on a left-side panel. User cannot affect the order of sewing within character, except definition of start and end point. Such location of the end point does not matter when thread between respective characters is trimmed, but it is wrong in case of nearest point connection between characters.
Start point is marked by small cross bottom-left side. This is another method to change which stitch will be last. Two approaches are presented here: Duplicate and Mirror command help to create symmetrical objects. It means that it does not snap selected node to nodes of actually edited object, only to nodes of other objects. Now create second column object.
Main Menu – Edit
It is possible to select them all and group them into a single item in the list, for easier manipulations like moving, scaling, etc.
When doing a complex outline, some outline parts start not on end of previous part, but on its beginning, instead. Create Second Edge command works on columns and objects with manjal sides. In such a case, start last column on the other side left. Nodes are snapped only if they are near to the Work Area edges, guide linesother nodes, grid lines or edges of other objects, respectively.
Manual Digitizing of Lettering
Use this function to place beginning of the new part exactly on beginning of previous part. Use Delete Whole Edge command to erase whole edge and start its creation anew.
Select connection tool and create connection path to the new start point.
Note that this object is listed in the Object Inspector list at the right side of the screen. Green arrows mark the center nodes of the curves. You can use “group 1” command that is intended for lowest level groups. Select Column tool or Column with Pattern toolwhich is the same as previous, but uses texture on wide parts.
The second edge will be parallel to the first and the segment end will be placed after each element of edges.